XDLXVIP.tlk Driver Reference
Algodue Elettronica DLX Controller for VIP D3 Driver
This driver requires that you have TAS-HMITalk 8.04 installed.
XDLXVIP driver allows you to connect with ElControl VIP D3
devices through the DLX Communication Controller. Default
communication settings for DLX controller are 9600,N,8,1.
Power Meters
ELCONTROL VIP D3 Meters using DLX controller
COMMAND DESCRIPTION:
This command reads the voltage, current, active power,
cos, apparent power, reactive power and frequency of the
three phase system measured by the VIP connected to
the specified position of the addressed DLX node.
PROPERTY SETTINGS REQUIRED:
HMITalk1.DriverDataType = Analog Input
HMITalk1.DriverNumPoints = 1-7
HMITalk1.DriverP0 = DLX Logic Number (1-255). If set to 0,
indicates that the DLX node will be addressed by
using the serial number indicated in the DriverP6
parameter.
HMITalk1.DriverP1 = Number of the VIP connected to the
DLX Node. Valid numbers are 1 to 4 only.
HMITalk1.DriverP2 = 1
HMITalk1.DriverP6 = A 9-char serial number to be used to
address the DLX node when DriverP0 is set to 0.
The serial number can be found in the DLX data plate.
Example: DLX430003
RETURNS:
- HMITalk1.PointValue(0) = THREE-PHASE SYSTEM VOLTAGE V[V]
- HMITalk1.PointValue(1) = THREE-PHASE SYSTEM CURRENT I[A]
- HMITalk1.PointValue(2) = THREE-PHASE SYSTEM ACTIVE POWER P[W]
- HMITalk1.PointValue(3) = THREE-PHASE SYSTEM POWER FACTOR Cos%
- HMITalk1.PointValue(4) = THREE-PHASE SYSTEM APPARENT POWER S[VA]
- HMITalk1.PointValue(5) = THREE-PHASE SYSTEM REACTIVE POWER Q[VAr]
- HMITalk1.PointValue(6) = FREQUENCY f[Hz]
[1005] DRIVER (Internal): Invalid driver stage
[1300] PROTOCOL (Timeout): No answer
[1433] PROTOCOL (Format): Validation error in device response
[2001] CONFIG (DataType): Analog outputs are not supported by this driver
[2002] CONFIG (DataType): Digital inputs are not supported by this driver
[2003] CONFIG (DataType): Digital outputs are not supported by this driver
[2266] CONFIG (NumValues): Too many values requested (max=7)
[3034] CONFIG (P0): Invalid DLX logic number (0-255)
[3581] CONFIG (P1): Invalid VIP number (1-4)
[4038] CONFIG (P2): Invalid command (1 only)
[6029] CONFIG (P6): Must be a 9-char serial number
This driver requires that you have TAS-HMITalk 8.04 installed.
Driver Source Code Last Update: 03/08/2004 14:07:26
Driver Reference Last Update: 10/30/2008 17:36:53
© 1990-2008, CPKSoft Engineering. All rights reserved.