skip to the main content area of this page
Driver Details

Download complete driver list...


 

XUDC3000: Honeywell UDC 3000 Universal Digital Controllers Driver v10.0


XUDC3000: Honeywell UDC 3000 Universal Digital Controllers Driver

General Information:


XUDC3000 driver allows you to connect to the HONEYWELL UDC3000, UDC5000 and UDC6000 controllers. The protocol uses is the ASCII protocol, not the DMCS protocol, and the controller must be configured for RS-422/485.

Pin assignment should be:
  • UDC3000 pin 7 ------> TX+/RX+ in the PC or converter

  • UDC3000 pin 8 ------> TX-/RX- in the PC or converter

  • If you cannot communicate or if you are using RS-485 to connect to the device, you should set the RTS signal during the communication. This can be done by setting the RTSEnable argument when calling the read and write methods. If you still cannot communicate, check that your RS-485 cables are not inverted.

    This driver was developed according to the information contained in the 'Product Manual UDC 3000 RS-422/485 Communications Option' version 51-51-25-08 12/88. Some differences where detected in the protocol actually used by the controller with which tests where made. This controller was an UDC 3000 model DC3004-0-40A-2-00-0111. Using this driver with different models could cause some errors, such as timeout errors.

    Important note:

    A delay may appear when changing some data in the controller, such as SetPoint #1 that can take over 30 seconds to be acknowledged.


    Available Commands:



    Supported Devices:

    (This list is only indicative and may exist other unlisted equipment that are also communicable with this driver).


    This driver includes:



    Available Downloads:



    To purchase a license please contact Engineering CPKSoft to any of our contact options.
    Return to All Drivers
    Licenses

    The licenses of all our drivers are unlimited in terms of the number of machines where they can be used, the number of I/O that can read or written, and the number of components that can be included in each application.

    After purchasing a license, the owner can use the driver and all its components to assemble and distribute as many applications to as many users as needed.

    The license owner retains full control of his applications by deciding himself what target machines can they be run at. For this, each driver is provided with two runtime license management tools: GetPCId.exe and MakeLic.exe.