skip to the main content area of this page
Driver Details

Download complete driver list...


 

XU9G500: Honeywell UDC9000 via Gateway 500 Read Driver v10.0


XU9G500: Honeywell UDC9000 via Gateway 500 Read Driver

General Information:


XU9G500 Allows you to connect to Honeywell UDC9000 controllers, via Gateway 500, using a modified version of the transparent mode protocol for old devices.

The connection with the Gateway must be made via RS-232 or through an ethernet/serial converter.

Important note:If the Gateway is configured to operate in D mode (Half Duplex),

the RTS must be conveniently wired between the PC RS-232 and the Gateway RS-232. If the Gateway is configured to operate in E Mode (Duplex), the RTS pin must be shorted with the Signal Ground pin in the Gateway RS-232 (it is not necessary to short it on the PC side).


Available Commands:



Supported Devices:

(This list is only indicative and may exist other unlisted equipment that are also communicable with this driver).


This driver includes:



Available Downloads:



To purchase a license please contact Engineering CPKSoft to any of our contact options.
Return to All Drivers
Licenses

The licenses of all our drivers are unlimited in terms of the number of machines where they can be used, the number of I/O that can read or written, and the number of components that can be included in each application.

After purchasing a license, the owner can use the driver and all its components to assemble and distribute as many applications to as many users as needed.

The license owner retains full control of his applications by deciding himself what target machines can they be run at. For this, each driver is provided with two runtime license management tools: GetPCId.exe and MakeLic.exe.