skip to the main content area of this page
Driver Details

Download complete driver list...


 

XIDECM3: Idec Izumi Micro3 Programmable Controller Protocol Driver v10.0


XIDECM3: Idec Izumi Micro3 Programmable Controller Protocol Driver

General Information:


XIDECM3 driver was designed to support the IDEC IZUMI MICRO3 controllers.

Serial communication is RS-485 at the PLC side. You can use a RS232C/RS485 Converter HD9Z-T11 to convert electrical signals between RS-232C and RS-485 to communicate with a computer using a RS-232 port.

Communication is half-duplex, being the PC always the master and the PLC always behave as a slave in the RS-485 network.

This driver supports both types of end codes for messages. Terminator can be CR (default for the PLC) or CR+LF. The terminator can be selected using F10+F3+FUN8 in the Micro3 configuration software (CUBIC).

Communication parameters can be:
  • Baudrate = 1200, 2400, 4800, 9600 (default), 19200 bauds.

  • Start bits = 1

  • Data bit = 7 (default), 8

  • Stop bit = 1 (default), 2

  • If you are communicating with a RS-485 network in 1:N communication computer link system, it is suggested that you configure your driver to raise the RTS signal while transmitting and lower it while receiving.

    If you are commnicating in 1:1 communication, it is suggested that you keep the RTS signal raised during the whole communication.


    Available Commands:



    Supported Devices:

    (This list is only indicative and may exist other unlisted equipment that are also communicable with this driver).


    This driver includes:



    Available Downloads:



    To purchase a license please contact Engineering CPKSoft to any of our contact options.
    Return to All Drivers
    Licenses

    The licenses of all our drivers are unlimited in terms of the number of machines where they can be used, the number of I/O that can read or written, and the number of components that can be included in each application.

    After purchasing a license, the owner can use the driver and all its components to assemble and distribute as many applications to as many users as needed.

    The license owner retains full control of his applications by deciding himself what target machines can they be run at. For this, each driver is provided with two runtime license management tools: GetPCId.exe and MakeLic.exe.